Filter
Top Products
Advanced Operations
61
GB
7 When setting is finished, press the middle of the
control wheel to return to the normal indicator screen.
8 Set the shutter speed and aperture.
• The shutter speed is calculated as follows to suit the selected flash
frequency and number of flashes.
Number of flashes (TIME) ÷ Flash frequency (Hz) = Shutter speed
For example, when ten flashes and 5 Hz are selected, 10 ÷ 5 = 2 requires a
shutter speed of longer than two seconds.
9 When the flash is fully charged, press the shutter
button to take the photo.
• The distance at which the proper exposure is obtained with a single flash is
displayed on the LCD panel.
(The distance is not shown when using upward flash bounce, when
communication with the camera is off, or when an off-camera cable is used)
• To prevent shaking, the use of a tripod is recommended during multiple
flash photography.
• Test flash will flash at the selected frequency/number/level while the TEST
button is being pressed if [1 TIME] is selected in the MENU settings. When
[3 TIMES] or [4 SEC] is selected, the flash three times or the four second
modeling flash has priority.