Filter
Top Products
GB
68
[A] Wireless flash photography using
the HVL-F60M as the off-camera flash
Use only an off-camera flash unit, using the light from the built-in flash as a signal.
1 Attach the flash unit to the camera and turn the power
of the flash unit and camera on.
2 Set the camera's flash mode to wireless (WL).
• The setting method differs depending on the camera used. For details, refer
to the operating instructions of your camera.
• When the camera is set to wireless flash, the flash unit also changes
automatically to wireless and the WL RMT mode's normal indicator screen
appears.
The flash channel information is transmitted to the camera. (If the [WL
CTRL] flash mode indicator is shown, change it to [WL RMT] on the
MODE screen.)
3 Remove the flash unit from the camera and raise the
built-in flash.
• Make sure that the flash mode indicator on the LCD panel of the flash unit
is showing [WL RMT].
4 Select the wireless remote setting of the flash unit.
• See page 71 for more details.
• At this time, if the wireless remote setting is MANUAL REMOTE or
MANUAL REMOTE 2 you can manually adjust the power level. (See the
wireless remote setting table on page 72)
Built-in flash
HVL-F60M