Filter
Top Products
55
Using the Menu
HVR-A1U/A1N 2-639-667-13(1)
EXEC
Touch [NEXT][EXEC-A] or [EXEC-
B] and the recording setting changes to
the registered one. Touch [BACK] to
register again or touch [END] to finish the
operation.
By touching [SET] on the [EXEC] screen,
you can select [TRANS TIME], [TRANS
CURVE] or [REC LINK], and you can use
the start timer.
TRANS TIME
Select transition time (2 to 15 seconds).
(The default setting is 4 seconds.)
TRANS CURVE
Select the transition curve. The transition
curve changes as follows.
*1: parameter level
*2: transition of time
LINEAR
Make the transition linearly.
SOFT STOP
Make the transition slowly at the end.
SOFT TRANS
Make the transition slowly at the
beginning and end, and linearly in
between.
START TIMER
Set the timer to start the shot transition.
OFF
The timer is not used.
5 sec
Start the shot transition after 5 seconds.
10 sec
Start the shot transition after 10 seconds.
20 sec
Start the shot transition after 20 seconds.
REC LINK
OFF
Not change when the recording starts.
SHOT-A
Change to SHOT-A when recording starts.
SHOT-B
Change to SHOT-B when recording starts.
• You cannot select [SHOT TRANS] while
recording.
• If you register [SHOT TRANS], the [WHITE
BAL.] setting is also registered at the same
time.
• The recording angle varies during [SHOT
TRANS].
• Use the tripod because [STEADYSHOT] does
not function.
PictBridge PRINT
See page 75.