Filter
Top Products
90
DCR-DVD92/DVD103/DVD203/DVD403/DVD602/DVD653/DVD703/DVD803
2-587-622-11 (1)
Troubleshooting (continued)
Disc
The disc cannot be removed.
•
Make sure the power source (battery pack or AC Adaptor) is connected correctly (p.17).
•
Remove the battery pack from the camcorder, then attach it again (p.17).
•
Attach a charged battery pack to the camcorder (p.17).
•
The temperature of your camcorder is extremely high. Turn off your camcorder and leave it
for a while in a cool place.
•
Moisture condensation has occurred with the disc. Turn off your camcorder and leave it for
about 1 hour (P.109).
•
Finalizing is interrupted by turning off your camcorder. Turn on your camcorder and remove
the disc after finalizing is completed.
Remaining disc space indicator is not displayed.
•
Set [DISC REMAIN] to [ON] to always display the remaining disc space indicator (p.68).
The indicators of the disc type and the recording format on the LCD screen are
grayed out.
•
The disc may be created other than your camcorder. You can play back with your camcorder,
but you cannot record additional scenes.
Recording
Refer also to “Adjusting the image during recording” (p.91).
Pressing REC START/STOP or PHOTO does not record movies/still images.
•
Slide the POWER switch down repeatedly to light up (Movie) or (Still) lamp.
•
Your camcorder is recording the scene you have just shot on the disc. You cannot press
PHOTO while [CAPTURE] or appears on the LCD screen (p.28, 32).
•
The disc has run out of space. Use a new disc or format the disc (DVD-RW/DVD+RW only,
p.51).
•
The DVD-RW (VIDEO mode)/DVD+RW has been finalized. Make a disc to be able to
record additional scenes (p.50).
•
The temperature of your camcorder is extremely high. Turn off your camcorder and leave it
for a while in a cool place.
•
Moisture condensation has occurred with the disc. Turn off your camcorder and leave it for
about 1 hour (p.109).
The ACCESS lamp lights up even when you stop recording.
•
Your camcorder is recording the scene you have just shot on the disc.
The shutter sound is not heard when you record a still image.
•
Set [BEEP] to [ON] (p.68).