Filter
Top Products
25
DCR-HC90 2-548-307-11(1)
Recording/Playback
feet).
• Remove any dust from the surface of the flash
lamp before using it. Flash effect may be
impaired if heat discoloration or dust obscures
the lamp.
• The flash charge lamp flickers when charging
the flash, and remains lit when the battery
charge is complete. (In the CAMERA-TAPE
mode, it takes a while to fully charge the flash
lamp since it charges its battery with the flash
lamp open.)
• If you use the flash in bright places such as
when shooting a backlit subject, the flash may
not be effective.
• Attaching a conversion lens (optional) may
create a shadow.
• You can change the brightness of the flash by
setting [FLASH LEVEL], or you can prevent
the redeye by setting [REDEYE REDUC], in
[FLASH SET] (p. 43).
To adjust the exposure for backlit
subjects ................................
To adjust the exposure for backlit subjects,
press BACK LIGHT to display
. To
cancel the back light function, press BACK
LIGHT again.
To adjust the focus for an off center
subject (SPOT FOCUS) ..............
See [SPOT FOCUS] on page 42.
To fix the exposure for the selected
subject (Flexible spot meter) ......
See [SPOT METER] on page 40.
To record in mirror mode ............
Open the LCD panel 90 degrees to the
camcorder (), then rotate it 180 degrees
to the lens side ().
• A mirror-image of the subject appears on the
LCD screen, but the picture will be normal
when recorded.
To use a tripod ........................
Attach the tripod (optional: the length of
the screw must be less than 5.5 mm (7/32
in.) to the tripod receptacle using a
tripod screw.
Playback
To play back the images in sequence
...........................................
See [SLIDE SHOW] on page 48.
To use PB zoom ..................
You can magnify pictures from about 1.1 to
5 times the original size.
Magnification can be adjusted with the
power zoom lever or the zoom buttons
on the LCD frame.
Play back the picture you want to
magnify.
Magnify the picture with T (Telephoto).
Touch the screen at the point you want
to magnify within the displayed frame.
Adjust the magnification with W (Wide
angle)/T (Telephoto).
To cancel, touch [END].
• You cannot change the zoom speed with the
zoom buttons on the LCD frame.
Continued