Filter
Top Products
68
You can automatically search for the point where the recording date changes and start
playback from that point (date search).
Use the Remote Commander for this operation.
Use this function to check where recording dates change or to edit the tape at each
recording date.
(1) Set the POWER switch to VCR.
(2) Press SEARCH MODE on the Remote Commander repeatedly until the DATE
SEARCH indicator appears on the screen. The indicator changes as follows:
DATE SEARCH t PHOTO SEARCH t PHOTO SCAN t (no indicator)
(3) When the current position is [b], press . to search towards [a] or press >
to search towards [c]. Your camcorder automatically starts playback at the
point where the date changes.
Each time you press . or > your camcorder searches for the previous or
next date.
To stop searching
Press x.
Notes
•The date search function works only for tapes recorded in the Digital8 system.
•If one day’s recording is less than two minutes, your camcorder may not accurately
find the point where the recording date changes.
If a tape has a blank portion between recorded portions
The date search function may not work correctly.
Searching a recording by date
– DATE SEARCH
[a][b][c]
JUL 5 2002JUL 4 2002 DEC 31 2002
3
2
SEARCH
MODE
DATE
00
SEARCH
DATE
01
SEARCH