Filter
Top Products
TrackSnap Manual
Model TS-DSC-S40-01
Page 5 of 12 Version
TS S40.01 This document comprises information provided by Suppliers and is
assumed to be correct.
Draft
DIP Switch Settings
PixController 10-Position DIP Switch
Introduction
The 10-Position DIP switch on the PixController board is used to setup how the board controls the attached
cameras, functions in day only, night only, 24 hour mode, and many more features. Listed below are
instructions on how to setup the DIP switch feature on the LE board.
Default Setting
The default settings for your camera are marked in Yellow
All switches Down (Off) except SW6 and SW10 Up (ON) and a summary is listed:
• 10 Sec PIR Delay
• 24 hour mode of operation
• Sony S40 Camera
• Continuous movement movie setting
• Green PIR LED ON
PIR Delay Setting
Switches 1 and 2 control the delay between PIR events. This setting is used so you can limit or not limit the
number of photos taken when a motion event triggers your board. For example when you set your system up
on a track you will want the 10 second delay setting so you can c
apture as many photos as possible, but when
setup over a feeder you want to use the 10 minute PIR delay so you limit the number of photos of one animal.
PIR Delay Switch 1 Switch 2
10 Seconds Down/Off Down/Off
2 Minutes Down/Off Up/On
5 Minutes Up/On Down/Off
10 Minutes Up/On Up/On
Mode Setting
Switches 2 and 3 control the mode of operation of your PixController board. Here you can setup if the board is
to function 24 hours a day, night only, or day only. The last setting sets up the day/night sensor light detection
level. This is useful for setting up your PixController board to detect light/darkness levels.
Mode Switch 3 Switch 4
24 Hour Operation Down/Off Down/Off
Night Only Down/Off Up/On
Day Only Up/On Down/Off
Day/Night Sensor Calibration. Up/On Up/On