Filter
Top Products
TrackSnap Manual
Model TS-DSC-S40-01
Page 6 of 12 Version
TS S40.01 This document comprises information provided by Suppliers and is
assumed to be correct.
Draft
Camera Attached Setting
Switches 5, 6, and 7 setups which camera is attached to your PixController board. Note: Even though there
are 2 different PIC controller chips available for the PixController LE (Original and LE II) your camera is using
the Original chip. Both are listed below are the settings for the corresponding controller chip for reference on
which other cameras can be used.
Camera (Original LE) Switch 5 Switch 6 Switch 7
Sony/Canon LANC Camcorder - Plug-n-Play Down/Off Down/Off Down/Off
ACC-Terminal - Plug-n-Play Down/Off Down/Off Up/On
Sony DSC-PXX (Sony P32/P41) Down/Off Up/On Down/Off
Minolta X20, Sony DSC-UXX (Sony U30) Down/Off Up/On Up/On
RSS (D380/D370/35mm always on mode) Up/On Down/Off Down/Off
RSP (on/off digital camera mode using external supply) Up/On Down/Off Up/On
RSP3i (on/off mode, internal supply, D370/D380) Up/On Up/On Down/Off
RSP4i (on/off mode, internal supply, D390/D395) Up/On Up/On Up/On
Camera (LE II) Switch 5 Switch 6 Switch 7
Sony/Canon LANC Camcorder in VTR mode - Plug-n-Play Down/Off Down/Off Down/Off
Sony/Canon LANC Camcorder in Photo mode - Plug-n-Play Down/Off Down/Off Up/On
Sony DSC-S40/DSC-S600 Down/Off Up/On Down/Off
Samsung A402 Down/Off Up/On Up/On
Olympus D-425 Up/On Down/Off Down/Off
Digital Concepts 2.1 (DC 2.1) Up/On Down/Off Up/On
DVR - Wireless (DVR control mode for wireless video cameras)
Up/On Up/On Down/Off
Olympus D-360L “Hardwire” Up/On Up/On Up/On
Picture Mode Setting
Switch 8 controls the operation of the attached camera. You can either setup your camera in digital still mode,
or movie/double photo mode. If you want to take digital movies with your digital camera you must have your
digital camera setup in movie mode. If your camera setting is in RSP mode, however, you can setup Charge
Mode On/Off, which is used to keep your camera settings. Note, when the board is setup in LANC mode these
setting will not apply. You must follow the “LANC Video Delay Setting” listed below.
Picture Mode Switch 8
Still / RSP Charge Mode off Down/Off
Movie or Double Photo / RSP Charge Mode On Up/On
Camera Mode Setting
Switch 9 controls fast/slow camera operation. This is useful for setting up fast/slow refresh mode in RSS
camera mode, or setting up a delay for larger memory cards. If switch 8 is setup in “Movie Mode” then this
switch setting is for 10 or 15 second movie clip, or the time delay between double photo modes. If you want to
take digital movies with your digital camera you must have your digital camera setup in movie mode. Note,
when the board is setup in LANC mode these setting will not apply. You must follow the “LANC Video Delay
Setting” listed below.
Camera Mode Switch 9
Fast / 10 second digital movie clip Down/Off
Slow / 15 second digital movie clip Up/On