Filter
Top Products
24
Control
XCD-SX910CR/X710CR
XCD-SX910UV
XCD-SX910/X710
Actual control can be carried out by setting registers
from F0F00800 onward.
ddd indicates the control value expressed as a 12 bit
hexadecimal number.
xxx indicates that any setting made will be ignored.
Brightness control
Address Data
F0F00800 82000ddd Adjusts the black level.
AE reference control
Address Data
F0F00804 82000ddd Sets the AE reference value.
Shutter (exposure time) control
Address Data
F0F0081C 82000ddd Controls shutter using the manually
set relative value.
83000xxx Sets to AUTO.
C2000xxx Controls shutter using the absolute
control value.
F0F00970 After F0F0081C has been set to
Absolute value control, set exposure
time using this register.
Gain control
Address Data
F0F00820 82000ddd Sets Gain manually.
83000xxx Sets Gain to AUTO.
Pan/Tilt control
Address Data
F0F00884 82000ddd Sets Pan manually.
F0F00888 82000xxx Sets Tilt manually.
(See page 25.)
Indicates an
arbitrary value
using a 32-bit
floating point
value.
White Balance control (XCD-SX910CR/
X710CR only)
Address Data
F0F0080C 82bbbrrr Sets R and B Gain.
“bbb” sets B Gain, “rrr” sets R Gain.
Hue (G Gain) control (XCD-SX910CR/
X710CR only)
Address Data
F0F00810 82000ddd Sets G Gain.
Optical Filter control (Bayer pattern
selection) (XCD-SX910CR/X710CR only)
Address Data
F0F0088C 82000ddd Selects the Bayer pattern.
The following Bayer patterns are available.
Pattern 0
Pattern 1
Pattern 2
Pattern 3
G B
RG
B G
GR
R
G
GB
G
R
BG
Trigger control
Address Data
F0F00830 82000000 Sets to Hardware Trigger Mode0.
82010000 Sets to Hardware Trigger Mode1.
82E00000 Sets to Software Trigger Mode0. *
82E10000 Sets to Software Trigger Mode1. *
F0F0062C* 80000000 Outputs a software trigger.
In Trigger Mode0, automatically reset
to 0 when exposure ends.
00000000 In Trigger Mode1, ends exposure if
“0” is set.
* These features comply with IIDC v.1.31.