Filter
Top Products
XCI-SX1 SDK / SDK Technical Manual
MSDOS Required file system support for mass storage
devices
SCSI support Required support for mass storage devices
NFS support Required support to enable the system to be
accessed through NFS mount
Big Physical Area support Used by the camera driver to reserve large
memory area at boot time
To apply the following configurations, go to /usr/src/linux and run
make menuconfig and start going through the options. After all the
configurations are set, exit from the configuration and make sure to save
the changes made. The .config file is now updated and contains the
new configurations made.
The pre-configured .config files are stored in the SDK
/buildtree/src/kernel/normal,fme, with which you can start
kernel configuration. The normal/.config is used for SDK kernel. Just
copy .config file to /usr/src/linux then proceed make
menuconfig.
2.2.2 Kernel Compilation
Run make dep in order to generate dependency information and cause
various build magic to occur. Occasionally, cleaning up the sources
before building from scratch is advisable. Run make clean to delete all
previously created object files. To build a compressed and ready to be
installed kernel image, run make bzImage. This command creates the
bzImage file in /usr/src/linux/arch/i386/boot/. Lastly, run
‘make modules’ to build the various components chosen to be built as
modules in the previous section.
2.2.3 Kernel Installation
If kernel compilation is successful, the built kernel is now ready to be
installed. Please copy bzImage to directory grub bootloader specify
(Refer to UM_SDK.pdf document). In the 2GB CF SDK itself, the kernel
is installed in /boot directory (Refer to /boot,
/boot/grub/grub.conf).
8