Filter
Top Products
XCI-SX1 SDK / SDK Technical Manual
Make sure that all the locale requirements are present in
/usr/share/i18n/locales directory and the charmap
requirements are in /usr/share/i18n/charmaps directory. The
created locale environments are created stored in /usr/lib/locale
directory. Sometimes, this directory still needs to be created.
One way to verify the support for locale environment is through the
xterm command. Running the LC_CTYPE=[locale env] exterm
command on the X11’s terminal should open a new terminal without any
warnings of the locale environment specified is supported.
If ja.SJIS environment still fails after creation of the said local
environment, add the line below to /etc/locale.alias to allow the
ja.SJIS locale environment support.
ja.SJIS ja.sjis
2.5.1.3 XFree86 Customized Settings
The XFree86 settings have been customized so that it will have the
same environment as the 128MB CF image. Please refer below for the
altered configurations.
• /etc/X11/XF86Config
The same configuration files are applied with target CF (128MB)
system.
• /usr/X11R6/bin/XFree86
/usr/X11R6/bin/XFree86_smartcam
The XFree86_smartcam is used on the target CF (128MB) system
and linked to /usr/X11R6/bin/X.
• /usr/X11R6/lib/fonts, font.org
/usr/X11R6/bin/locale, locale.org
The fonts and locale directory is link to ones in the target CF
(128MB) system.
The .org directory has full content. You can pick some if you need
one.
• /usr/X11R6/lib/X11/xinit/xinitrc
Key repeat rate is set for efficiency of development.
16