Filter
Top Products
GX5201
5
SVAT ELECTRONICS
Now
You
Can
See
the preset level, the monitor will display the picture from that camera for a few seconds,
and the beeper will sound. To avoid searching the channels that do not have
cameras/transmitters assigned to them, set those corresponding dip switches (located on
the back panel of the monitor) to the OFF position.
The dwell/cycle time (time taken to switch between cameras) is preset to four seconds
and can be adjusted between 2-30 seconds. To adjust the dwell/cycle time, hold down
both the AUTO and MANUAL buttons simultaneously. The monitor will chime for each
second it is adding to the dwell time. Release the buttons, and the LED light will flash for
each second that was added to the dwell time. Increasing the dwell/cycle time past 30
seconds will revert it back to 2 seconds.
Manual
To view a specific camera on the monitor, press the MANUAL button. The monitor will
switch to a different camera each time the MANUAL button is pressed. To avoid
searching the channels that do not have cameras assigned to them, set those
corresponding dip switches (located on the back panel of the monitor) to the OFF
position.
MONITOR FUNCTIONS
Power
- Press to turn the monitor on/off
Alarm Volume
- The ALARM VOLUME of the monitor can be changed by adjusting the Alarm
- Volume Tuner located on the top of the monitor.
Volume
- The sound level can be adjusted by pressing the + or - buttons on the front of the
monitor.
Menu
- Press the Menu button to get the following options:
- LED on, adjust brightness using + or -
- LED flashing, adjust color using + or -
- LED off, adjust contrast using + or -