Filter
Top Products
www.svat.com
WIRING DIAGRAM
INSTALLATION
CAUTION: Before connecting the power and switching the unit ON make sure all wiring is
connected properly.
1. Connect the power cable (supplied) to the back of the monitor.
2. Using the DIN cable connect the four cameras to the back of the monitor. Each end of the cable
will only fit in either the camera or the monitor. Align the pins on the connection jack, do not
force the plug, it should go in freely. (FIG-1)
4. When using only 1-2-3 cameras the empty channel will remain grey.
5. Using a standard RCA Cable (not supplied) you can connect the monitor to an extra monitor/vcr
or add additional cameras (use the BNC adapters provide to convert the BNC slots to RCA)
WARNING: When using BNC camera input jacks do not connect another camera to the same channel
using a DIN connection. There is only one camera allowed per channel.
5
(FIG-1)