Filter
Top Products
17
Photos Do Not Capture Subject of Interest
Try to set your camera up in an area where there is not a heat 1.
source in the camera’s line of sight.
In some cases, setting the camera near water will make the 2.
camera take images with no subject in them. Try aiming the
camera over ground.
Try to avoid setting the camera up on small trees that are prone 3.
to being moved by strong winds.
Remove any limbs which are right in front of the camera lens.4.
PIR Sensor LED Flashes/Doesn’t Flash
When the camera is in the “Setup” mode, the PIR Indicator LED on 1.
the front of the camera will ash when it senses motion. This is
for setup purposes only and will help the user aim the camera.
During use, the LED will not ash when the camera takes an 2.
image. This is to help keep the camera hidden from game.
Camera won’t retain settings
Make sure that you have been saving the changes to any parameter 1.
settings that you made while in Setup mode, by pressing “OK”
after changing the setting. If you don’t save your new setting after
changing it, the camera will continue to use the original default
setting for that parameter.
Troubleshooting / FAQ