Technicolor - Thomson 5400LDK Camcorder User Manual


 
4-2
Operator's Manual LDK 5400 - Triax Adapter for LDK 100 Series
Location of Controls and Functions
bts1311
Progr
Prod
Eng
Call
CVBS (Option)
Eng
Off
Prod
Loc
Ext
Mix
Mic
Dc in
Scrip
Light
VF
Ext
Rear
Power on
Breaker
Front
Rear
Front
48V
Power Supply
Power switch
The power switch has two positions:
On : Power to camera is switched on.
Off : Power to camera is switched off.
When you switch off the power, the access rights that
were obtained by the use of the PIN code are disabled
and the camera starts at the assigned user level when
switched on again.
Power on indicator
The power on indicator lights when power is supplied
to the camera and the camera power switch is on.
Circuit breaker button (BREAKER)
If excessive current flows in the camera the circuit
breaker trips and shuts off power to all the units. If this
happens check the units for faults and if necessary
take corrective action before pressing the circuit
breaker button to reset the power.
DC input socket
This socket accepts a DC supply voltage of12V
Nominal (11V to 17V) for powering the camera in
stand-alone mode for service purposes. Maximum
power consumption 20W.
Caution
The input voltage must not exceed 17 Vdc.
Triax cable socket
The power supply for the camera is normally supplied
from the Base Station via the the triax cable. The triax
cable is connected to this socket.
The triax cable also carries all the video, audio/
intercom and control signals between the camera
and the Base Station.
1
1
2
2
3
3
4
4
5
5