Filter
Top Products
EN7
1
3
2
To DC Input
connector
To DC OUT
connector
To AC outlet
AC Power
Adapter/Charger
DC cord
ATTENTION:
Before detaching the power source,
make sure that the camcorder’s power
is turned off. Failure to do so can result
in a camcorder malfunction.
USING THE BATTERY PACK
1
Tilt the viewfinder upward 1.
2
With the arrow on the battery pack pointing
downward, push the battery pack slightly against the
battery pack mount 2, then slide down the battery
pack until it locks in place 3.
•If the battery pack is attached with its mark set
in the wrong direction, a malfunction may occur.
To Detach The Battery Pack . . .
....
tilt the viewfinder upward 1 and slide the battery pack
up slightly while pressing BATTERY RELEASE to detach it.
Power cord
Approximate recording time
BATTERY RELEASE
Button
NOTES:
●
Recording time is reduced significantly under the
following conditions:
•
Zoom or Record-Standby mode is engaged repeatedly.
•
The LCD monitor is used repeatedly.
•
The playback mode is engaged repeatedly.
●
Before extended use, it is recommended that you
prepare enough battery packs to cover 3 times the
planned shooting time.
USING AC POWER
Use the AC Power Adapter/Charger (connect as shown in the illustration).
NOTES:
●
The provided AC Power Adapter/Charger features automatic voltage selection in the AC range from 110 V to
240 V.
●
For other notes,
੬
pg. 6.
Battery pack
BAT 600
LCD monitor on/
Viewfinder off
1 hr.
(35 min.)
LCD monitor off/
Viewfinder on
1 hr. 15 min.
(40 min.)
( ) : when the video light is on.
VMD6 EN(02/39) 28/08/00, 15:467