Filter
Top Products
- 8 -
6-2 Installing to Wall
The camera head at shipping is set for installing the camera to the ceiling. The camera
head angle should be changed when installing to a wall.
(1) Turn 2 screws of
1
to unfasten the camera head.
Note :
• The camera head is connected to the inside with cable, do not pull it with strength.
Otherwise the inner connector may be broken and the image may not appear.
(2) Reverse the camera head 180° from default setting and install it. The direction of
the camera head is shown as above. With the “Bottom” mark
2
upwards, the tilt
range is adjusted as shown above.
(3) Fasten the screw
1
to fix the camera head.
1
2
Tilt Range
"Bottom" Mark
Camera Head
6-3 Installing the Cover
As shown in the illustration, adjust the cover
position to the camera’s installation position and
turn it right to install it.