Filter
Top Products
1919
Adjusting the Lens
Based on the live image retrieved from the camera, adjust the camera lens by
performing the following:
To adjust the viewing angle
1. Turn the lens module left and right.
2. Loosen the tilt adjustment screws on both side of the camera and then turn the lens
module up and down. Upon completion, tighten the screws.
3. Turn the lens cover to adjust the image orientation. (Ceiling mount)
Using an analog monitor
This camera is able to output an analog NTSC video signal from the Video Out
connector.
Adjustment of Viewing angle is possible using a portable monitor without using a
personal computer when installing.
Use the included Video Out cable for this purpose.
1
2 3
Loosen
Tighten
Pan 350° Rotate 340°Tilt: 55°
NOTE
Wall mounting
This camera is adjusted to the optimal position for ceiling mounting by default.
When installing to the wall, don't turn a lens cover 180 degrees.
And change the following setup of the camera.
Video>Image>General setting>Video orientation:
Lens Focus
l
This camera is using the deep focus lens. This camera comes into focus from 1.5m to
innite distance. No need to readjust the focus.
l
The surrounding part of image is a bit out of focus if compared to the central part, due to
the lens spec. It is not failure.
l
There may be a difference of focus if compared to the left, right, top and bottom of image. It
is not failure.