Filter
Top Products
9
Notes on Use and Installation
l
Do not aim the camera at the sun
Never aim the camera at the sun even with the camera power off.
l
Do not shoot intense light
Intense light such as a spotlight may cause a bloom or smear. A vertical stripe may appear on
the screen. However, this is not a malfunction.
l
Treat the camera with care
Dropping or subjecting the camera to intense vibration may cause it to malfunction.
l
Avoid Volatile Liquid
Do not use volatile liquids, such as an insect spray, near the unit. Do not leave rubber or
plastic products touching the unit for a long time. They will leave marks on the nish. Do not
use a chemically saturated cloth
.
l
Never touch internal parts
Do not touch the internal parts of the camera other than the parts specied
.
l
Do not submerge in water
The camera has some protection to water (see IP rating), and can be used indoors or
outdoors. If the camera was submerged in water, turn off the power and contact your dealer.
l
Keep the camera installation away from video noise
If cables are wired near electric lighting wires or a TV set, noise may appear in images. In this
event relocate cables or reinstall equipment.
l
Check the ambient temperature and humidity
Avoid using the camera where the temperature is hotter or colder than the specied operating
range. Doing so could affect the internal parts or cause the image quality to deteriorate.
Special care is required to use the camera at high temperature and humidity.
l
Should you notice any trouble
If any trouble occurs while you are using the camera, turn off the power and contact your
dealer. If you continue to use the camera when there is something wrong with it, the trouble
may get worse and an unpredictable problem may occur.