Filter
Top Products
6
The following parts are located on the front panel of the switch:
¾ Reset: Press this button for five seconds or above to reset the software setting back to factory
default setting.
¾ LEDs
Name Status Indication
On(Green) The switch is powered on.
Power
Flashing/Off The switch is powered off or power supply is abnormal.
Flashing The switch is working normally.
System
On/Off
The switch is working abnormally.
On
A 1000Mbps device is connected to the corresponding port, but
no activity.
Green
Flashing Data is being transmitted or received.
On
A 10/100Mbps device is connected to the corresponding port, but
no activity.
Link/Act
Yellow
Flashing Data is being transmitted or received.
2.3.2 Rear Panel
The rear panel of TL-SG2008 features a power socket and eight ports. Its rear panel is shown as
the following figure.
Figure 2-2 Rear Panel of TL-SG2008
¾ 1000Mbps Ports: Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or
1000Mbps. Each has a corresponding LED on the front panel.
¾ Power Socket: Connect the female connector of the power cord here, and the male connector
to the DC power outlet. Please make sure the voltage of the power supply meets the
requirement of the input voltage (12V/1A for TL-SG2008).
Return to CONTENTS