Filter
Top Products
14
www.vivotek.com
T: 886-2-22404099
F: 886-2-22404097
Power on
Make sure all cables are correctly and firmly connected before turning on Network Camera. Turn on
cameras, sensors, alarm devices, and then attach the power adaptor of Network Camera to the electric
power socket*. After the POST (power-on self test) is complete and the result is successful, Network
Camera is ready for software configuration as described in this manual. At this stage, network speed and
video modulation type are automatically detected. If the detection of video modulation fails,
administrators may change the setting on the configuration page. Refer to the configuration section for
further information.
Connect the power jack of the power adapter to Network Camera prior to plugging the utility end
into the utility power socket. It will reduce accidental electric surge shock.