B-5
OPERATION
B-5
POWER FEED™ 25M
FIGURE B.1a
CASE FRONT CONTROLS (CODE 11456 and
higher) (See Figure B.1a)
1. Left DISPLAY window
Shows WIRE FEED SPEED or AMPERAGE.
2. Left KNOB
Adjusts values in left display.
3. Status LED
Illuminates a steady green when communicating to
the power source properly.
4. MSP4 display window
Shows detailed welding and diagnostic information.
5. Left Button
Changes the MSP4 display to show the Weld Mode
or Arc Control.
6. Procedure Button
Selects A or B procedure, or gun control.
7. 2-Step/4-Step Button
Toggles between 2-step and 4-step trigger opera-
tion.
8. 5-pin connector
Trigger connector for a push-only gun.
9. ON/OFF switch
Controls power to the POWER FEED™ 25M.
10. 6-pin connector
Connector for a remote control.
11. Cover
Covers location for optional water cooling line.
12. 7- pin connector
Connector for a push-pull gun.
13. Right Display window
Shows VOLTAGE or TRIM.
14. Right Knob
Adjusts values in the right display.
15. Thermal
Lights when the drive overheats.
16. Set-Up
Lights when feeder is set-up
17. IR port
Used to transfer information to palm computers,
etc.
18. Right Button
Changes the MSP4 display to show Start Options
or End Options.
19. Set Knob
Changes the value on the MSP4 display.
20. Memory Buttons
(For selection of common procedures.)
1
13
2
3
14
4
17
18
19
20
10
11
12
16
5
7
8
9
6
15
