Filter
Top Products
- 33 -
www.4XEM.com
Restoring the factory defaults will erase any previous settings. Reset or restore
the system after power on.
Appendix
A. Troubleshooting
Status LED
The following table lists the LED patterns which indicate camera status.
Blinking Red Power is being supplied to the camera.
Steady Green The camera is booting up.
Blinking Orange & Green The camera is trying to obtain an IP address.
Steady Orange An IP address is successfully assigned to the camera.
Blinking Orange & Red The camera is working.
Fast Blinking Orange & Red During firmware upgrading.
Reset and Restore
There is a button in the back of the Network Camera. It is used to reset the system or
restore the factory default settings. Sometimes resetting the system sets the system
back to normal state. If the system problems remain after reset, restore the factory
settings and install again.
RESET: Click on the button.
RESTORE:
1. Press on the button continuously.
2. Wait for self-diagnostic to run twice.
3. Free the button as soon as the second self-diagnostic starts.
Status LED Color Description