Filter
Top Products
Troubleshooting (cont.)
The built-in flash doesn’t work.
◗ The flash may be turned off. Check the flash setting.
◗ The batteries may be too weak. Replace them.
The recorded image is blurry.
◗ The subject may have moved while you were taking the picture. Hold the camera steady
and take the picture again.
◗ You may have moved the camera before it beeped, signaling that the image was captured.
Take the picture again and hold the camera steady until you hear the beep.
◗ You may have used the wrong focus setting. Make sure the subject’s distance from the
lens and the focus setting match. The flash illuminates subjects up to a distance of only
about 7 feet (2.6 m).
The recorded image is too dark.
◗ There may not be enough light. Set the flash to the Auto or Fill-in setting.
◗ The subject may be too far away for the flash. The flash illuminates subjects up to a dis-
tance of only about 8.5 feet (2.6 m).
54