Filter
Top Products
Figure 5-5 represents pointing the dome precisely at 225° from North (Southwest) with a tilt of 25°
below the virtual horizon. Panning to the left points the dome towards the South. Panning to the right
points the dome towards the West.
Figure 5-5: Pointing the dome precisely southwest with a tilt elevation of –25°
S
W
SW
-25
Changing the Display of Direction Indicators
1. Select On-Screen Text Display from the Dome Configuration Menu.
2. Move the highlight to Direction Indicator.
3. Change the setting.
• Select On to display the direction information.
• Select Off to prevent the direction information from displaying.
The default setting is Off.
4. Select Exit. The Dome Configuration Menu appears. Continue with What To Do Next on page
5–11.
Configuring the Display of Name Information
Use the Name Configuration Menu to select which name information appears on-screen. To
display this screen, select Name Configuration Menu from the On-Screen Text Display screen.
The following screen appears:
NAME CONFIGURATION MENU
CAMERA NAME ON/OFF
AREA NAME ON/OFF
PRESET NAME ON/OFF
PATTERN NAME ON/OFF
ALARM NAME OFF/ON
FOCUS FAR to program names
RESET PROGRAMMABLE NAMES
EXIT
You can choose to enable or disable the display of camera, area, preset, pattern, and alarm names
from this screen. You can reset all programmable names to their default settings. You may also
initiate name programming from this screen. See Assigning or Changing Name Information on
page 5–7.
5–6 SpeedDome Ultra VII Operator's Manual