Filter
Top Products
Installing Windows for Workgroups
To support networking with your DOS-compatibility hardware, you need to
install software that supports ODI (Open Data-Link Interface) drivers. Follow
these steps:
1 Install Windows for Workgroups 3.1.1, electing to not install the networking software.
2 Follow the instructions in “Installing NetWare Client Software,” earlier in this appendix.
3 Follow the instructions in “Installing NetManage’s Chameleon TCP/IP Software,” earlier
in this appendix.
Installing Spry’s Air Series TCP/IP software
IMPORTANT
You must not have MacTCP installed when you run DOS TCP/IP
software; the two will conflict with one another.
You can use the IPX and TCP protocols at the same time in the PC
environment or in the Mac OS, or you can use one protocol in the PC
environment and the other protocol in the Mac OS. However, you cannot use
the same protocol in both environments at the same time.
If you want to use the IPX protocol in the PC environment and you have
previously installed MacIPX in the Mac OS, remove MacIPX from the
Control Panels folder or select AppleTalk as your network interface in the
MacIPX control panel.
If you want to use the TCP protocol in the PC environment and you have
previously installed MacTCP in the Mac OS, remove MacTCP from the
Control Panels folder or select an interface other than Ethernet in the
MacTCP control panel.
You must have Windows installed before you can install Spry’s Air Series
TCP/IP software. If you need to reinstall Windows, see “Reinstalling PC
Software” in the section “Reinstalling the DOS-Compatibility Software” in
Chapter 8.
163
Installing Network Management Software