Filter
Top Products
NetCamera NVW
A02-IPCAM4-W54 63
Address of the IP Wireless Security Night Vision
Camera is
within the same subnet as your workstation.
Click “Start”, “Setting”, “Control Panel”, and the “Network” icon.
Select TCP/IP from the “Network” dialog box and from the
“TCP/IP Properties” dialog box click “Specify an IP address”.
If the IP Wireless Security Night Vision Camera is situated on
a different subnet than your workstation, you will not be able to
set the IP address from this workstation. To verify make sure
the first 3 sections of the IP address of the IP Wireless
Security Night Vision
Camera corresponds to the first 3
sections of the workstation. Therefore the IP address of the IP
Wireless Security Night Vision
Camera must be set from a
workstation on the same subnet.
Question I cannot access the IP Wireless Security Night Vision
Camera from a web browser.
Answer
Other possible problems might be due to the network cable.
Try replacing your network cable. Test the network interface
of the product by connecting a local computer to the unit,
utilizing a standard Crossover (hub to hub) Cable. If the
problem is not solved the IP Wireless Security Night Vision
Camera might be faulty.
Question Why does the Power LED not light up constantly?
Answer
The power supply used might be at fault. Confirm that you are
using the provided power supply DC 5V for the IP Wireless
Security Night Vision Camera and verify that the power supply
is well connected.