Filter
Top Products
AXIS M1004–W Network Camera
System Options
1. Enter the path to the certicate directly or click Browse to locate the le.
2. Click Upload.
To upload a client certicate/client private key:
1. Use the Client private key eld if uploading one combined le. For each le, enter the path to the le or click Browse to
locate the le.
2. Click Upload.
To remove a CA certicate/Client certicate/Client private key, click Remove.
Note
Installed certicates will be deleted if the product is reset to factory default.
For more information about IEEE 802.1X, see IEEE802.1X on page 42.
SOCKS
SOCKS is a networking proxy protocol. The Axis product can be congured to use a SOCKS server to reach networks on the other
side of a rewall or proxy server. This functionality is useful if the Axis product is located on a local network behind a rewall, and
notications, uploads, alarms, etc need to be sent to a destination outside the local network (for example the Internet).
SOCKS is congured under System Options > Network > SOCKS. For more information, see the online help
.
QoS (Quality of Service)
QoS (Quality of Service) guarantees a certain level of a specied resource to selected trafc on a network. A QoS-aware network
prioritizes network trafc and provides a greater network reliability by controlling the amount of bandwidth an application may use.
The QoS settings are congured under System Options > Network > QoS. Using DSCP (Differentiated Services Codepoint) values, the
Axis product can mark different types of trafc.
SNMP
The Simple Network Management Protocol (SNMP) allows remote management of network devices. An SNMP community is the
group of devices and management station running SNMP. Community names are used to identify groups.
To enable and congure SNMP in the Axis product, go to the System Options > Network > SNMP page.
Depending on the level of security required, select the version on SNMP to use.
Traps are used by the Axis product to send messages to a management system on important events and status changes. Check Enable
traps and enter the IP address where the trap message should be sent and the Trap community that should receive the message.
Note
If HTTPS is enabled, SNMP v1 and SNMP v2c should be disabled.
Traps for SNMP v1/v2 are used by the Axis product to send messages to a management system on important events and status
changes. Check Enable traps and enter the IP address where the trap message should be sent and the Trap community that
should receive the message.
The following traps are available:
• Cold start
• Warm start
• Link up
51