Filter
Top Products
AXIS Q1602 N etwork Camera
System Options
To change the date and time settings, select the preferred Time mode under New Server Time:
• Synchronize with computer time sets date and time according to the computer’s clock. With this option, date and
time a re set once and w ill not be updated a utomatica lly.
• Synchronize with NTP Server obtains date and time from an NTP server. With this option, date and time settings are
updated continuously. For information on NTP settings, see
NTP Con figuration, on page 38
.
If using a host name for the NTP server, a DNS server must be configured. See
DNS Configuration, on page 38
.
• Set manually allows you to m a nuall y set date and ti m e.
If using a n NTP server, select your Time zone from the dro p-dow n list. If required , c heck A utoma tically adjust for daylight saving
time changes.
The Date & Time Format Used in Images is the date and time format displayed as a text overlay in the video stream. Use the
predefined formats or see
File Naming & Date/Time Formats
in the online help for information on how to create custom date and
time formats. To include date and time in the overlay text, go to Video & Audio and select Include date and Include time.
Network
Basic TCP/IP Settings
The Axis product supports IP version 4 and IP version 6. Both versions can be enabled simultaneously, and at least one version
must always be enabled.
IPv4 Address Confi guration
By default, the Axis product is set to use IPv4 (IP version 4) and to obtain the IP address automatically via DHCP. The IPv4 settings are
configured under System Options > Network > TCP/IP > Basic.
DHCP (Dynamic Host Configuration Protocol) allows netw ork administrators to centrally manage and automate the assignment of
IP addresses. DHCP should only be enabled if u sing dynamic IP address notification, or if the DHCP can update a DNS server. It is
then possible to a ccess the Axis p roduct by name (host name).
If DHCP is enabled and the p roduct cannot be accessed, run AXIS IP Utility to search the network for connected Axis products, or reset
the product to the factory default settings (see
page 45
) and then perform the installation again.
To use a static IP address, ch ec k Use the following IP address and specify the IP address, subnet mask and default router.
IPv6 Address Confi guration
If IPv6 (IP version 6) is enabled, the Axis product will receive an IP address according to the con figuration in the network router.
To enable IPv6, go to System Options > Network > TCP/IP > Basic. Other settings for IPv6 should be configured in the network router.
ARP/Ping
The IP address can be set using ARP and Ping . For instructions, see the product’s Installation Guide.
ARP/Ping is enabled by default. To disa ble , uncheck the box under System Options > Network > TCP/IP > Basic.
The A RP/P ing service is automatically disabled two minutes after t he product is started, or as soon as an IP address is s et. To reset the
IP address, the product must be restarted to activate ARP/Ping for an additional two minutes.
Pinging the product is still possible when this service is disabled.
37