Filter
Top Products
AXIS Q1602 N etwork Camera
System Options
Port Status
The list on the System Options > Ports & Devices > Port S tatus page shows the status of the product’s input and output ports.
Maintenance
The Axis product provides several maintenance functions. These are available under System Options > Maintenance.
Click Restart to perform a correct restart if the Axis prod uct is not behaving as expected. This will not affect any of the current
settings.
Click Restore to reset most settings to the factory default values. The fo llowing settings a re not affected:
• the boot protocol (DHCP or static)
• the static IP address
• the default router
• the subnet mask
•thesystemtime
• the IEEE 802.1X settings
• the focus position
Click Default to reset all settings, including the IP address, to the factory default values. This button should be used w
ith caution. The
Axis product can also be reset to factory default using the control button, see
Reset to Factory Default Setting s, on page 45
.
To identify the product or test the Status LED, click Flash LED under Identify and specify the duration in seconds, minutes or hours.
This can be useful for identifying the product among other pro ducts installed in the sam e location.
For information about firmware upgrade, see
Upgrading the Fi rm ware, on page 46
.
Support
Support Overview
The System Op tions > Support > Support Overview page provides information on troubleshooting and contact information,
should you require technical assistance.
See also
Troubleshooting, on page 46
.
43