Filter
Top Products
AXIS Q1602 N etwork Camera
Hardware Overview
1.
Power LED
2.
Network LED
3.
Control button
4.
Iris connector
5.
Power connector
6.
I/O terminal connector
Connectors
For technical specifications, see
page 51
.
Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE).
NOTICE
Due to local regulations or the environmental a nd electrical conditions in which the product is to be used, a shielded
network cable (STP) may be appropriate or req u ired. Any network cables that are routed in o utdoor environments or similar
shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. See
for regulatory requirements.
Audio in (pink) - 3.5 mm inp
ut for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).
Audio out (green) - 3.
5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker
with a built-in amplifier. A stereo connector must be used for audio out.
SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage.
NOTICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > System
Options > Storage > SD Card and c lick Unmount.
Co
ntrol button - The control button is u sed for:
5