Filter
Top Products
AXIS Q1635 Network Camera
Install the Hardware
NONO
NO
TICETICE
TICE
Due to local regulations or the environmental and electrical conditions in which the
product is to be used, a shielded network cable (STP) may be appropriate or required. Any
network cables that are routed outdoors or in demanding electrical environments shall be
shielded (STP) and intended for their specic use.
1. Optionally connect external input/output devices, such as alarm devices. See on page 15
for information on the terminal connector pins.
2. Optionally connect an active speaker and/or external microphone.
3. Connect the camera to the network using a shielded network cable.
4. Connect power, using one of the methods listed below:
- PoE (Power over Ethernet). PoE is automatically detected when the network
cable is connected.
- Connect an external power adapter to the power connector block. See
Connectors and Buttons on page 13.
5. Check that the indicator LEDs indicate the correct conditions. See the table on page
12 for more details. Note that the Status LED can be congured to be unlit during
normal operation.
6. Optionally insert a microSD card (not included) into the SD card slot.
NONO
NO
TICETICE
TICE
To prevent corruption of recordings, the SD card should be unmounted before it is ejected.
To unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
Access the Product
Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on www.axis.com/techsup/
Adjust Focus
To adjust the zoom and focus follow these instructions:
Note
• Set focus as precisely as possible with the focus ring or Focus Assistant before starting
automatic ne tuning. Using the focus ring normally gives the best result.
• The iris should always be opened to its maximum while focusing. This gives the smallest
depth of eld and thus the best conditions for correct focusing.
19