Filter
Top Products
14 en | Installation FLEXIDOME 5000 AN
AM18-Q0648 | v1.0 | 2013.03 Installation Manual Bosch Security Systems
To disassemble the unit proceed as follows:
1. Use the special screwdriver bit to loosen the three tamper-
resistant screws in the trim ring (the screws remain in
place).
2. Remove the trim ring and dome by pulling them from the
base.
3. Remove the inner liner (with sealing ring) by pulling it off
of the base.
4. Remove the pink protective foam.
3.3 Mounting the unit
There are several ways to mount the unit. The method of
mounting depends on the type of surface and whether other
mounting hardware, such as an electrical box, a surface box or
other accessories are used.
Note:
Figure 3.2 Surface-mount
Surface mounting box
Camera module and mounting base
Inner liner (with sealing ring)
Trim ring
Dome