Filter
Top Products
16 en | Installation FLEXIDOME 5000 AN
AM18-Q0648 | v1.0 | 2013.03 Installation Manual Bosch Security Systems
Figure?3.4?Flush mounting - electrical box (4S)
3.3.3 Surface mounting
When using the surface mounting box:
– With a side connection, remove the cap covering the side
entrance.
With a rear connection, leave the cap in place.
– Attach the conduit to the mounting box.
– Release the two clips at the bottom of the watertight
connection compartment to remove it from the mounting
box.
– Open the cover of the watertight compartment in the
mounting box by releasing the five clips.
– Run the power and video cables through separate rubber
grommets into the watertight compartment.
– Run the cable from the camera into the watertight
compartment through the supplied grommet.
– Make the connection inside the watertight compartment
and clip on the cover to seal it.
1. Two screws (not supplied)
2. Integrated camera unit and base
3. 4S electrical box