Filter
Top Products
FLEXIDOME 5000 AN Connection and set-up | en 19
Bosch Security Systems Installation Manual AM18-Q0648 | v1.0 | 2013.03
4 Connection and set-up
4.1 Power and video connections
The wiring harness has a BNC connector to accept the video
coax cable (with male BNC connector) and two stripped low
voltage power wires for connection to a power connector. A
UTP adapter (VDA-455UTP) is available as an optional accessory
to allow a UTP video cable to be connected to the BNC
connector.
The easiest way to connect the cables is as follows:
1. Bring the building connections through the surface cable
hole so that they hang clear.
2. Partially insert two screws into the pre-drilled holes (or
adapter plate).
3. Using one of the keyholes, hang the mounting base of the
camera module on one screw temporarily; tilt the base
slightly to gain access to the cable connections.
4. Connect the BNC connector of the camera module to the
video coax cable.
5. Connect the stripped power wires (red +, brown –) to the
power supply connector.
Note
For a DC supply the polarity is important. Incorrect polarity
does not damage the camera but it will not switch on.
6. In damp environments ensure that the connections are
sealed. (The surface mounting box and the other mounting
accessories have a sealed compartment for this purpose.)
7. Push the connections back through the surface cable hole.
8. Secure the mounting base of the camera module to the
surface with three screws.