Filter
Top Products
20 en | Connection and set-up FLEXIDOME 5000 AN
AM18-Q0648 | v1.0 | 2013.03 Installation Manual Bosch Security Systems
4.2 Setting up the camera
4.2.1 Camera positioning
To assist in setting up the camera, connect a monitor to the
miniature 2.5 mm jack socket (2). This socket provides a
composite video signal (with sync). An optional cable (code
number S1460) is available for making this connection. When
the S1460 cable is attached, there is no video available on the
BNC connector to avoid interference.
Figure 4.1 Camera parts
CAUTION!
The Heater will be hot when in operation - Do not touch.Always
switch the heater off when working on the camera, refer to
Section 4.2.4 Heater, page 23 and Section 5.6.4 Connections
submenu, page 41.
1. Heater
2. Monitor jack socket
A
B
C