Filter
Top Products
Corner-mount No-grip Camera Installation | en 15
Bosch Security Systems, Inc. Instruction Manual F.01U.172.707 | 3.0 | 2011.02
6. Mount the housing using the supplied mounting screws.
7. Ensure that the power and video cables are not crimped or
stressed after the camera has been mounted.
3.5 Camera - Directional Adjustment
Both the camera and the LED array can be adjusted for
optimum picture quality. The camera lens can be tilted on its
axis via two adjustment screws on the mounting bracket. It can
also be moved closer to or farther from the viewing window.
1. Mount the Camera/LED Array Assembly into the housing.
2. Connect the video and power wires.
3. Check the picture for quality and directional alignment.
4. If you must adjust the camera’s viewing angle or picture
quality, remove the Camera/LED Array Assembly. Refer to
Figure 3.6.
Figure 3.6 Camera Directional Alignment
5. Loosen both adjustment screws for tilt or horizontal
directional alignment.
6. Once optimal position is obtained, tighten the screws.
Number Description
1LED Array
2Tilt Adjustment
3 Horizontal Adjustment
4 Camera/Lens Assembly
5 Adjustment screw