Bosch Appliances EX36N Security Camera User Manual


 
18 en | Installation Corner-mount No-grip Camera
F.01U.172.707 | 3.0 | 2011.02 Instruction Manual Bosch Security Systems, Inc.
3.8 Camera Re-assembly
1. Ensure that all wires are properly connected, that all holes
are sealed against moisture penetration, and that all
mounting screws are tight.
2. Slide the square foam pad over the camera’s lens. Ensure
that the pad is as close to the faceplate viewing window as
possible and the photocell is not covered by the foam pad.
The foam pad is not symmetrical. Ensure that the LEDs are
not covered when installing the pad.
3. Re-attach the faceplate with the six tamper-resistant
screws. Tighten screws carefully, but do not overtighten.
4. Power up the camera and check its operation. Refer to
Figure 3.8 below.
Figure 3.8 Camera Re-assembly
Number Description
1Photocell
2Foam pad