6 en | Safety Corner-mount No-grip Camera
F.01U.172.707 | 3.0 | 2011.02 Instruction Manual Bosch Security Systems, Inc.
FCC Information
This equipment has been tested and found to comply with the
limits for a digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. As part
of its normal operation, this device can generate radio
frequency energy and if not installed and used in accordance
with the installation manual may cause interference to radio
communications. However, there is no guarantee that
interference will not occur on a particular installation. If the
device does cause interference to radio or television reception,
the user is encouraged to try to correct the problem by one or
more of the following measures:
– Fit Ferrite beads on all cable to and from the power supply
box, within the box walls.
– Route the composite cable between the camera and the
power supply in steel conduit piping over the entire run of
the cable up to and including connection to a deep conduit
base fitted under the camera and a conduit fitting adaptor
in the wall of the PSU box.
– Contact a Bosch Service Center for further advice.