Filter
Top Products
52 en | Configuration Using a Web Browser VideoJet X10 SN
DOC | V4.0 | 2009.06 Installation and Operating Manual Bosch Security Systems
means that you can record the standard data stream on a hard drive and record alarm
images on the mobile CF card, for example.
5. Check the boxes for the Overwrite older recordings option to specify which older
recordings can be overwritten once the available memory capacity has been used.
Recording 1 corresponds to Stream 1, Recording 2 corresponds to Stream 2.
Formatting Storage Media
You can delete all recordings on a storage medium at any time.
1. Click a storage medium in the Managed storage media list to select it.
2. Click the Edit button below the list. A new window will open.
3. Click the Formatting button to delete all recordings in the storage medium.
4. Click OK to close the window.
Deactivating Storage Media
You can deactivate any storage medium from the Managed storage media list. It is then no
longer used for recordings.
1. Click a storage medium in the Managed storage media list to select it.
2. Click the Remove button below the list. The storage medium is deactivated and removed
from the list.
5.22 Advanced Mode: Remote Video Device
You can allow a remote video device to use the VideoJet X10 SN storage media. This means
you can record video images from a camera that does not have its own storage media, for
example. Once you have entered the IP address of the remote video device and saved it by
pressing Set, the VideoJet X10 SN is then displayed for selection in the Storage Management
for the remote video device.
!
CAUTION!
If older recordings are not allowed to be overwritten when the available memory capacity has
been used, the recording in question will be stopped. You can specify limitations for
overwriting old recordings by configuring the retention time (see Section 5.24 Advanced Mode:
Retention Time, page 55).
!
CAUTION!
Check the recordings before deleting and back up important sequences on the computer's
hard drive.