Filter
Top Products
13
OPERATING YOUR BREVILLE MILK CAFÉ™
NOTE
A different frothing result may
be achieved depending on the
ingredients added.
Experiment with different milk
options, ingredients and frothing
discs to achieve the desired result.
SAFETY FEATURES
Standby
After 30 seconds of non use the milk frother
will enter standby mode and the button
surround will cease to illuminate.
To activate the milk frother out of standby
mode, press the START | STOP button.
Boil Dry Protection
The milk frother will automatically cease
to operate if the jug overheats. This can be
caused if the jug is empty, if liquid is below
the MIN measurement marking, or after
consecutive uses. Wait approximately 5
minutes for the milk frother to cool down
or fill the jug with water for faster cooling.
Once adequately cooled, you will be able
to activate the milk frother and
recommence frothing.
Thermal Fuse Protection
This feature protects the milk frother in
case of major fault.
The appliance will no longer be able to
operate. Immediately cease use and return
appliance to Breville.
Call Breville Customer Service on
Ph: 1300 139 798 (Australia) or
Ph: 0800 273 845 (New Zealand).
USING THE ‘COLD STIR’ SETTING
By selecting the ‘Cold Stir’ setting on the
temperature dial, you can froth cold or hot
milk without heating.
The ‘Cold Stir’ setting is ideal for making
cold beverages or blending ingredients.
The ‘Cold Stir’ setting will operate for
60 seconds.
NOTE
Avoid adding sugary powders using
‘Cold Stir’ setting. Toppings and
syrups work best.
ADDING INGREDIENTS
Using the measuring cap, gradually add
ingredients a few minutes after the stirring
cycle has commenced, allowing the milk to
warm first.
Always add ingredients slowly and in small
quantities. Adding ingredients too quickly
may cause the frothing disc to dislodge or
stop spinning.