Filter
Top Products
SETUP GUIDE
1. K1 - Mode Switch (OFF / SETUP/ ON) :
a) Power ON (UP position): Set K1 to ON position, The LCD display will show “BUSHNELL”
for about 2 seconds, and then will prompt to input your password.
Press Up or Down key to select the first password digit of 0-9.
Note: the factory programmed default password is 0000.
Press ENTER to confirm, the cursor will move to the next digit to the right.
Repeat the process using UP, Down and Enter keys to enter your four digit
password. Press ENTER to confirm, if the password is correct the LCD will
display EVENT/IMAGE.
The LCD will rotate through the DATE\TIME\EVENT&IMAGE displays
when pressing the Up and Down keys.
PASSWORD
0_ _ _
EVENT nn
IMAGE nn
If the password entered was correct, or if the password was never previously programmed, the unit
will be enabled after a 5 minute delay.
If the password is entered incorrectly 3 times the unit will be turned OFF automatically.
Before beginning the setup, insert 4 “D” size alkaline
batteries as indicated inside the battery compartment.
Switch and Setup Description
Switch Position/Setting
Switch #/Function UP CENTER DOWN
K1 (Operating
Mode)
On Setup Off
K2 (Image Mode) Still
- Movie
K3 (Day/Night
Mode)
24 Hour Day
(6AM-
6PM)
Night
(6PM-
6AM)
K4 (Camera Delay) 2 minutes 1 minute 30 seconds
Switch Position/Setting
Switch #/Function UP CENTER DOWN
K1 (Operating
Mode)
On Setup Off
K2 (Image Mode) Still
- Movie
K3 (Lighting Mode) LED - Incand.
K4 (Day/Night
Mode)
24 Hour Day
(6AM-
6PM)
Night
(6PM-
6AM)
K5 (Camera Delay) 2 minutes 1 minute 30 seconds
K1 K2 K3 K4
K1 K2 K3 K4 K5
Up/Down/Enter
Up/Down/Enter
6
7
Trail Scout 6LIM.indd 8-9 1/25/05 4:25:47 PM