Filter
Top Products
4. K3 () – (24Hr / DAY/ NIGHT) MODE:
K4 ()– (24Hr / DAY / NIGHT) MODE:
The Trail Scout has three working times:
(a)
24Hr: The Trail camera is working all day . When the PIR is sensed the unit will take
an image and record an EVENT.
(b) DAY: The Trail camera is only working in daytime (from 6:00 AM to 6:00 PM),
When the PIR (Passive InfraRed) is sensed the unit will take image and record EVENT.
If the PIR is sensed out of day-time, only an EVENT is recorded, an image is not taken.
(c)
NIGHT: The Trail camera is only working at night (from 6:00 PM to 6:00 AM),
When the PIR (Passive InfraRed) is sensed the unit will take image and record EVENT.
If the PIR is sensed out of night time, only an EVENT is recorded, an image is not taken.
5. K4 ()– (30s/1Min/2Min) CAMERA DELAY MODE
K5 () – (30s/1Min/2Min) CAMERA DELAY MODE:
There are three modes for taking delayed pictures: 30 Sec, 1 Min and 2 Min.
The unit will record EVENTS while CAMERA is in DELAY MODE each time the PIR senses motion.
(a) 30s: After the first picture, a second picture will be taken 30 seconds later.
(b) 1Min: After the first picture, a second picture will be taken 1 minute later.
(c) 2Min: After the first picture, a second picture will be taken 2 minutes later.
2. K2 – Image Mode Switch (STILL / MOVIE):
Set K2 to either of these settings:
(UP) STILL Photo Mode: Image resolution is 0.35MP (119600) or 2.1MP (119800/119900)
and photos are stored in JPG format.
(DOWN) MOVIE Mode: The camera can record a 15 second movie, the file format is AVI.
NOTE: The use of MOVIE Mode must be during daytime with models 119600 and 119800.
You can not record movies at night. However, MOVIE mode with the model 119900 CAN be
used at night when the camera is in the IR-LED mode.
3. K3 - Lighting Mode Switch (LED / Incand):
The Game camera has two modes for illumination in darkness:
(a) LED Mode:
When you use IR-LED light mode to take still picture at night, you must remove the FILTER
from the lens of the trail camera. The IR-LED (infrared) light is invisible to the naked eye, but
will provide illumination for the camera, use it when you do not want to alert the subject. This
mode will provide illumination for nighttime movie capture.
(b) Incand Mode: You can use Incandescent mode to take still pictures at night.
If you want to record movies using the MOVIE mode, you can not use Incand mode—you must
set K3 to LED Mode.
10
11
Trail Scout 6LIM.indd 12-13 1/25/05 4:25:48 PM