Filter
Top Products
45
With manual flash and multiple Speedlites, you can set a different flash
output for each slave unit.
All settings are done with the master unit.
1
Press the <D> button so
that <q> is displayed.
2
Press the <G> button
so that <y> blinks.
3
Select the flash ratio.
Turn the <9 > dial to select <l>
or <j>, then press the <8>
button.
4
Set the flash output.
Press the <8> button.
X The slave ID <m> will blink.
Turn the <9> dial to set the flash
output for <m>, then press the <8>
button.
The slave ID <n> will blink. Turn the
<9> dial to set the flash output for
<n>, then press the <8> button.
The slave ID <o> will blink. Turn the
<9> dial to set the flash output for
<o>, then press the <8> button.
X All the slave IDs will light.
Setting the Flash Output for Each Slave
A65_03.fm Page 45 Friday, August 17, 2007 2:40 PM
COPY