Filter
Top Products
23
When the Speedlite is attached to an EOS-1D series camera, you can
set the flash level manually for closeup subjects.
1 Set the camera and Speedlite.
Set the camera’s shooting mode to <q> or <W>.
Set the Speedlite to manual flash.
2 Focus the subject.
Focus manually.
3 Set up an 18% gray card.
Place the gray card at the subject’s position.
In the viewfinder, the entire spot metering circle at the center
should cover the gray card.
4 Press the <7> button. (3)
X The Speedlite will fire a preflash and the required flash output for
the subject is retained in memory.
X On the right side of the viewfinder, the exposure level indicator
will show the flash exposure level for the correct flash exposure.
5 Set the flash exposure level.
Adjust the Speedlite’s manual flash level and the
camera aperture so that the flash exposure level
aligns with the standard exposure index.
6 Take the picture.
Remove the gray card and take the picture.
Metered Manual Flash Exposures
This feature works only with EX-series Speedlites with manual flash coupled
with an EOS-1D series camera.
A65_02.fm Page 23 Thursday, November 23, 2006 1:27 PM