Filter
Top Products
7. Auto Exposure Bracketing (EOS 620 Only)
Use auto exposure bracketing when you want to choose the best exposure by changing the amount of exposure
on film intentionally. The range of bracketing is up to +/- 5 steps in 1/2-step increments.
1) Open the switch cover and press both the AF mode selector and battery check button simultaneously to
display the 0.0 and "AEB" indicating auto exposure bracketing.
· Once the buttons are depressed, you can remove your fingers because the 'AEB" display is held on for
approximately eight seconds. To clear this status within eight seconds, press the shooting mode selector.
2) Turn the electronic input dial to the desired bracketing value.
· If you set 1.0 in the display panel, for example, the camera automatically makes three continuous exposures
in sequence of -1.0 step of underexposure, correct exposure according to the camera's meter and +1.0 step of
overexposure. Then the auto exposure bracketing status automatically clears.
Notes
1. Three continuous exposures are automatically made regardless of the film winding mode.
2. The original focus remains locked during three continuous
exposures regardless of the AF mode.
3. To clear auto exposure bracketing before shooting, display the
"AEB" and preset bracket value again by following step 1) above,
then turn the electronic input dial until the bracket value returns to
0.0. (Clearing auto exposure bracketing is impossible while
shooting.)
4. Bulb cannot be used with auto exposure bracketing.
5. Auto exposure bracketing is impossible with a flash.