Filter
Top Products
101
Shooting - Selecting Particular Effects
5
Press the button, the button or click the main dial.
• To cancel the compensation, return the setting to using the main dial or
the B or A arrow on the omni selector.
6
Shoot the image.
Compensating the Flash Output.
In mode or when [Flash Adjust] is set to [Manual], the flash output can be
controlled in three steps, starting from FULL, when shooting. This setting is also
active with slave flash photography where multiple flashes are fired at the subject
from different positions because the pre-flash does not fire. When an externally
mounted flash is attached, its flash output can be controlled (Up to 1/16 from Full,
in 1/3 steps).
1
Press the button to turn on the LCD monitor.
2
Press the button.
3
Select using the C or D arrow on the omni selector.
4
Adjust the output using the main dial or
the B or A arrow on the omni selector.
• You can shoot the image right after selecting
settings by pressing the shutter button. This
screen will appear again, once the image is shot.
5
Press the button, the button or click the main dial.
6
Shoot the image.
e.g. Flash Output
• Some settings are not available with certain Shooting modes. Please refer to
Functions Available in Each Shooting Mode (p. 204).