Filter
Top Products
54
Setting the Image-recording Quality
The RAW image is the data output by the imaging element and
converted to digital data which is recorded on the memory card as is.
The RAW image is transferred to a personal computer where software
(provided) is used to adjust the image as needed. From the RAW
image, the software can develop and generate the adjusted image in
the desired type such as JPEG or TIFF.
This is a small RAW image which is one-fourth (approx. 2.5 megapixels) the
size of a normal RAW image. As with RAW images, sRAW images can be
developed and adjusted with the provided software. This image type is handy
when you do not need a very high resolution as a normal RAW image.
The maximum burst will vary depending
on the subject, memory card brands,
image-recording quality (image size and
JPEG quality), ISO speed, drive mode,
Picture Style etc.
The preceding page
lists the approximate maximum burst for
each image size. You can check the current maximum burst displayed
in the viewfinder on the right side.
About RAW
About sRAW
Maximum Burst During Continuous Shooting
At high ISO speeds, the maximum burst will greatly decrease.
The maximum burst is displayed even when a memory card is not in the
camera. Make sure that a memory card is loaded before taking a picture.
The maximum burst for <o> is displayed regardless of the drive mode
setting.
If the viewfinder displays “99” for the maximum burst, it means the maximum
burst is 99 or higher. If 98 or lower is displayed, the maximum burst is 98 or
lower. If you stop the continuous shooting, the maximum burst will increase.
After all the captured images are written to the memory card, the maximum
burst will be as listed on the preceding page.