Filter
Top Products
27
S T E P 1
Calibration
Adjusts the white balance to the correct value so that all the colors are scanned
correctly. Calibration takes approximately 1 minute. If the color balance of a
scanned image is off-balance, select this option to calibrate the scanner input.
Reset Default Settings
Returns the preference settings and all other settings to the factory default
settings. The tables list the major default settings.
Scan Mode Color (Photos)
Magnification 100%
Unit Pixels
Basic Resolution 72 dpi
Control Panel Position Center
Image Standard
Unsharp Mask Off
Descreen Off
Close Plug-in After Scan
This setting determines whether or not Plug-in Module CS-U closes automatically
after completion of the scanning job. After you install Plug-in Module CS-U, this
setting is set to on (Plug-in Module CS-U closes at completion of scanning). To turn
this feature off, open the [Preferences] menu and select [Close Plug-in After Scan].
This feature is switched off when you don’t see it marked with a check mark. To
switch the feature on, click it again to show the check mark.