Filter
Top Products
145
E
Additional Information
List of Messages
Message Explanation
SET THE TIME ZONE, DATE
AND TIME
You have not set the time zone, date and time. This message appears each
time you turn the power on until you set the time zone, date and time.
26
CHANGE THE BATTERY
PACK
Battery pack is exhausted. Replace or charge the battery pack.
15
THE TAPE IS SET FOR
ERASURE PREVENTION
Cassette is protected. Replace the cassette or change the position of the
protect switch.
150
REMOVE THE CASSETTE Camcorder stopped operating to protect the tape. Remove the cassette and
reinsert it.
23
CHECK THE HDV/DV INPUT DV cable is not connected, or the connected digital device is turned off. 106
CONDENSATION HAS BEEN
DETECTED
Condensation has been detected in the camcorder.
148
TAPE END Tape reached the end. Rewind the tape or replace the cassette. –
HEADS DIRTY, USE
CLEANING CASSETTE
Video heads are dirty. Clean the video heads.
147
NO CARD Memory card not is inserted into the camcorder. 24
NO IMAGES No images are recorded on the memory card. –
CARD ERROR A memory card error occurred. The camcorder cannot record or play back the
image.
The error may be temporary. If the message disappears after 4 seconds an
“ ” flashes red, turn the camcorder off, remove the card and reinsert the
card. If “ ” changes to green, you can continue recording/playback.
–
CARD FULL No remaining capacity on the memory card. Replace with another card or
erase images.
–
NAMING ERROR The folder and file numbers have reached their maximum value. –
UNIDENTIFIABLE IMAGE Image is not recorded with JPEG compression, or with a compression not
compatible with the camcorder, or the image file is corrupted.
–
THE CARD IS SET FOR
ERASURE PREVENTION
SD/SDHC memory card is set for erasure prevention. Replace the card or
change the position of the protect switch.
24
INCORRECT TAPE
SPECIFICATION PLAYBACK
IS RESTRICTED
You attempted to play back a tape recorded in a standard different than the one
to which is the camcorder is set. –
INPUT SIGNAL NOT
SUPPORTED
You attempted to input a video signal incompatible with the camcorder (for
example 720p).
106
PLAYBACK STD LOCKED
PLAYBACK IS RESTRICTED
When the playback standard is already set in the camcorder, you attempted to
play back a tape in a video standard different from that set.
95
PLAYBACK STD LOCKED
INCOMPATIBLE VIDEO INPUT
When the playback standard is already set in the camcorder, you attempted to
input a video signal in a standard different from that set.
106
COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED
You attempted to play back a copyright protected tape.
107
COPYRIGHT PROTECTED
DUBBING RESTRICTED
You attempted to dub a copyright protected tape. May also appear when an
anomalous signal is received during analog line-in recording, or during analog-
digital conversion of a copyright protected tape.
107